Product Overview
SPECIFICATIONS
Brand Name: Heltec Automation
Certification: NONE
Choice: yes
High-concerned chemical: none
Origin: Mainland China
semi_Choice: yes
The kit does not include a battery
If you have any questions, you can contact the store customer service staff as soon as possible
Connection example diagram
Note:
If you are connecting several series of lithium batteries, you need to connect tin to the corresponding solder pads.
For example, if you measure a 1S battery, you need to short-circuit tin on the solder pad corresponding to S1 of the board
Feature:
Voltage:6V
Current: 210MA
Process: Epoxy
Material: high rate solar cell epoxy resin AB glue, PCB or fiberglass backplane
Size: 133*73MM
Package include:
1*Solar panel
Solar charger
This is a supper mini Solar Lipo charger based on the CN3065 - a single lithium battery charge management chip.
This Solar charger provide you with the ability to get the most possible power out of your solar panel or other photovoltaic device and into a rechargable LiPo battery. Set-up is easy as well, just plug your solar panel into one side of the Solar charger and your battery into the other and you are good to start charging!
The output of the Solar Charger is intended to charge a single polymer lithium ion cell. The load should be connected in parallel with the battery. By default, the Solar charge comes set to a maximum charge current of 500mA with a maximum recommended input of 6V (minimum 4.4V). It's recommended that batteries not be charged at greater than their capacity rating.
Features:
Solar panel input: 4.4-6V
Max charge current: 500Ma
Interface: 2-pin JST connectors(or PH2.0)
Short circuit protection
Continuous Charge Current Up to 500mA
Battery status indication ( Red : Charging , Green: Charged )
Micro-USB Connector
Package A Include
1* Solar Panle
1* Solar Charger
3*Cable
1S Power display
How to use: Connect the positive and negative terminals of the display board to the positive and negative terminals of the battery under test, and the digital tube displays the real-time battery power
Display battery parameters:
(Remarks: N is the number of battery cells) (The following data is a reference value, there will be an error range of about 2%, do not shoot if high accuracy is required)
The battery voltage is greater than N × 3.3V, with 1 grid lit
The battery voltage is greater than N × 3.5V, with 2 grids on
The battery voltage is greater than N × 3.7V, with 3 grids on
The battery voltage is greater than N × 3.9V, with 4 grids on
The battery voltage is less than N × 3.3V, and the four-segment display is all off, indicating that the battery is below 3.3V, and it is time to charge the battery.
1S 18650 Battery Holder
CH2 Quick Splice Lock Wire Connector
Package B Include
All set Package Include (battery not include )
1* Solar Panel
1*1S display
1* Solar charger
1* 1S battery Holder
2* CH2 Connector
3* Cable
