Characteristics:

Can be used for heating embossing powder and shrink film.

Keep the part 3-5cm distance,heating at an angle of about 45 degrees until finished.

After completion, use a high-temperature heat gun for a few seconds.

It not only increases the hardness, but also increases the gloss.

The temperature is not adjustable; theoretically it can reach 200 degrees in a few seconds.

Do not heat for more than 10 minutes and blow at a 45 degree angle to avoid heat absorption, be careful when using a heat gun.

Specifcations:

Colour: black

Material: abs

Type: constant temperature

Operating temperature: 200°c / 390°f, reached in seconds

Rated power: 300 w

Power supply type: ac

Rated voltage: 220v and 230v

Power supply: 50hz

Running time: 8 minutes

Material: steel and plastic

Working temperature: 200 c

Rated power: 300 w

Rated voltage: eu plug (220v)

Plug type: eu plug

Instructions:

1.plug in the thermal stripper.

2.hold the thermal stripper without touching the hot nozzle.

3.hold the heat gun 5 to 6 cm from the workpiece and heat to approximately 45°c until the part is complete.

4.turn off the power to cool.